Cisco CRS-1 - Carrier Routing System Router Migration Manual page 89

Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
Command or Action
Step 10
do show controllers fabric fabric-backpressure
summary
Example:
RP/0/RP1/CPU0:router(admin-config)# do show
controllers fabric fabric-backpressure summary
Step 11
no controllers fabric rack 1 install-mode
Example:
RP/0/RP1/CPU0:router(admin-config)# no
controllers fabric rack 1 install-mode
Step 12
commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
Step 13
do show controllers rack-status all detail
Example:
RP/0/RP1/CPU0:router(admin-config)# do show
controllers rack-status all detail
What to Do Next
When all chassis in the multishelf system are operational and communicating with each other, it is time
to continue system configuration, as described in the documents in the
page
Troubleshooting Tips
For troubleshooting information, see the documents described in the
page
Example
The following example shows commands to enable power to the newly installed CRS-3 Fabric Card:
RP/0/RP0/CPU0:router#admin
RP/0/RP0/CPU0:router(admin)#config
RP/0/RP0/CPU0:router(admin-config)#no hw-module power disable loc 0/SM0/SP
RP/0/RP0/CPU0:router(admin-config)#commit
Verify that power has been enabled to the Fabric Node (state is not UNPOWERED).
RP/0/RP0/CPU0:router(admin)#show platform
Node
<snip>
0/SM0/SP
OL-13669-03
1-63.
1-63.
Type
FC-140G/S(SP)
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
How to Migrate to a Cisco CRS-3 Carrier Routing System (4-Slot)
Purpose
Displays the backpressure status for all racks.
• The status for the row labeled "Rack 1: All Groups
Received? :" should be "Yes."
Modifies the target configuration to change the Rack 1
configuration to normal mode.
Commits the target configuration to the router running
configuration.
Displays the status of all racks in the system.
• In a properly operating system, the rack status for all
racks should be Normal, and the server status should be
Present.
PLIM State
N/A PRESENT
"Related Documents" section on
"Related Documents" section on
Config State
PWR,NSHUT,MON
1-79