Cisco CRS-1 - Carrier Routing System Router Migration Manual page 229

Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
Output pkts 1024-1518 bytes = 0
Output pkts 1519-Max bytes
Output good pkts
Output unicast pkts
Output multicast pkts
Output broadcast pkts
Output drop underrun
Output drop abort
Output drop other
Output error other
Example: show controllers TenGigE xgxs Command
RP/0/RSP0/CPU0:Router# show controllers TenGigE 0/4/0/0 xgxs
Serdes Registers and info port: 0
EDC Status
Rx detected
Block lock
Tx aligned
The following example shows sample output for the show controllers TenGigE stats command for the
Cisco CRS 14-Port 10-Gigabit Ethernet LAN/WAN-PHY Interface Module:
RP/0/RP0/CPU0:Router# show controllers TenGigE 0/1/0/0 xgxs
Thu Oct
DTE XGXS
Current Alarm Status:
XGXS Lanes All Synchronized
XGXS Lanes Aligned
PHY XGXS
Previous Alarm Status:
NO XGXS Local Fault
TX Link UP
Current Alarm Status:
NO XGXS Local Fault
TX Link UP
Example: show controllers HundredGigE phy Command
The following example shows sample output for the show controllers HundredGigE phy command for
the Cisco CRS 1-Port 100-Gigabit Ethernet Interface Module:
RP/0/RP0/CPU0:router#show controllers HundredGigE 0/6/0/0 phy
Thu Oct
802.3ba PCS
Previous PCS Alarms:
Current PCS Status:
PCS is able to support 100GBASE-R
PCS is NOT Block Locked
PCS Rx Link Status is DOWN
PCS Errored Block Counts: 0
PCS Sync Header Error Counts: 0
Serdes section:
===============
All of 10 RX serial inputs detects loss of signal.
All of 10 cleanup PLL phase detectors are unlocked.
All of 10 clock multiplication units are locked.
OL-13669-03
: 000000070 - EDC tracking
: Yes
: Yes
: Yes
7 18:30:03.732 EST
7 09:43:10.274 EST
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
= 0
show controllers (Ethernet)
3-69