Creating RAID 0, 1, 5, or 6 using Intel
(detailed)
This section describes the process to set up RAID modes using the custom configuration
options.
®
Intel
RAID Software User's Guide
1. When the server boots, hold the <Ctrl> key and press the <G> key when the following
is displayed:
Press <Ctrl><G> to enter RAID BIOS Console
The Controller Selection screen appears.
2. Select a controller and click Start to begin the configuration.
3. Choose Manual Configuration and click Next (see
4. At the Disk Group Definition (DG Definition) screen, hold down the <Ctrl> key and
click each drive you want to include in the array or disk group.
See
"RAID Levels" on page 9
added.
Figure 22. Intel
5. Click Add To Array. If you make a mistake and need to remove drives, click Reclaim.
6. Click Next.
7. In the next screen, click Add to Span and then click Next.
for the required minimum number of drives that must be
®
RAID BIOS Console 2 - Add Physical Drives to Array
®
RAID BIOS Console 2
Figure
21).
73