Table of Contents
Advertisement
The blue-screen capture feature captures the video display contents before the IMM
restarts the server when the IMM detects an operating-system hang condition. A
system administrator can use the blue-screen capture to assist in determining the
cause of the hang condition.
Obtaining the IP address for the Web interface access
To access the Web interface and use the remote presence feature, you need the IP
address for the IMM. You can obtain the IMM IP address through the Setup utility.
To locate the IP address, complete the following steps:
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. If you have set both a
3. From the Setup utility main menu, select System Settings.
4. On the next screen, select Integrated Management Module.
5. On the next screen, select Network Configuration.
6. Find the IP address and write it down.
7. Exit from the Setup utility.
Logging on to the Web interface
To log on to the Web interface to use the remote presence functions, complete the
following steps:
1. Open a Web browser on a computer that connects to the server and in the
2. Type the user name and password. If you are using the IMM for the first time,
3. On the Welcome page, type a timeout value (in minutes) in the field that is
Note: Approximately 20 seconds after the server is connected to AC power, the
power-control button becomes active.
power-on password and an administrator password, you must type the
administrator password to access the full Setup utility menu.
Attention:
If you set an administrator password and then forget it, there is no
way to change, override, or remove it. You must replace the system board.
address or URL field, type the IP address or host name of the IMM to which
you want to connect.
Notes:
a. If you are logging on to the IMM for the first time after installation, the IMM
defaults to DHCP. If a DHCP host is not available, the IMM uses the default
static IP address 192.168.70.125.
b. You can obtain the DHCP-assigned IP address or the static IP address from
the server UEFI or from your network administrator.
The Logon page is displayed.
you can obtain the user name and password from the system administrator. All
logon attempts are documented in the IMM event log. A welcome page opens in
the browser.
Note: The IMM is set initially with a user name of USERID and password of
PASSW0RD (passw0rd with a zero, not the letter O). You have read/write
access. For enhanced security, change this default password during the initial
configuration.
provided. The IMM logs you off the Web interface if your browser is inactive for
the number of minutes that you entered for the timeout value.
Chapter 3. Configuring the server
121
Advertisement
Table of Contents
