Table of Contents
Advertisement
14. If the tape drive came with screws, secure the drive to the server chassis,
15. Connect one end of the tape drive cable to the USB or SATA connector on the
16. Connect the power cable to the tape drive and to the connector on the system
17. Reinstall the fan cage assembly.
82
IBM System x3500 M3 Type 7380: Installation and User's Guide
using the supplied screws.
system board, depending upon the type of tape drive that you are installing;
then, route the cable through the cable holders on the inside of the server and
connect the opposite end of the cable to the back of the tape drive (see
"Internal cable routing and connectors" on page 38 for more information.)
Note: If you are installing an RDX internal USB tape drive, use the
SATA-to-traditional power converter cable to serve as a bridge between the
optical power cable and the power connector on the RDX tape drive.
board (see "Internal cable routing and connectors" on page 38 for more
information.)
Advertisement
Table of Contents
