Table of Contents
Advertisement
6. Close the rear adapter-retention bracket.
7. Install and lock the left-side cover (see "Completing the installation" on page
8. Reconnect the external cables and power cords; then, turn on the attached
Installing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the left-side cover (see "Removing the left-side cover" on page 57).
4. Unlock the retention latch by pushing it down toward the system board.
105).
devices and turn on the server.
on page 35.
Chapter 2. Installing optional devices
95
Advertisement
Table of Contents
