Maytag MED5800TW - Electric Dryer Technical Education page 51

7. Place a 13/16˝ wrench on the back of
the blower wheel, and a 7/16˝ wrench on
the front of the drive motor shaft (flatted).
Turn the drive motor shaft to the right
(clockwise) and loosen the blower wheel
(left-hand thread).
13/16˝ Wrench
7/16˝ Wrench
8. Remove the four screws from the air duct
at the rear of the unit and pull the duct for-
ward so that you can access the blower
wheel (see page 4-18 for the procedure).
9. Spin the blower wheel clockwise and re-
move it from the drive motor shaft (see
the top right photo).
Loosen
Flatted
Drive Shaft
Loosen
REASSEMBLY NOTE : When you reinstall the
drive motor, make sure that the rounded locator
tab is in the bracket slot, as shown below.
Locator Tab In Slot
4-11
Blower Wheel