Table of Contents
Advertisement
8. Seat the cover and secure it with one screw.
9. When you turn the computer on, it should automatically recognize the
total memory capacity. Use the HW Setup program to verify that the
added memory is recognized. If it is not recognized, check the module's
connection.
Removing memory module
To remove the memory module, make sure the computer is in boot mode
then:
1. Turn the computer off and remove all cables connected to the
computer.
■
If you use the computer for a long time, the memory modules will
become hot. In this case, let the memory modules cool to room
temperature before you replace them.
■
Do not try to remove a memory module with the computer turned on or
turned off in Standby and Hibernation mode. You can damage the
computer and the memory module.
2. Turn the computer upside down and remove the battery pack
(refer to Chapter 6,
3. Remove one screw securing the memory module cover.
4. Lift off the cover.
5. Use a slender object such as a pen to press two latches on either side
of the memory module to the outside. The memory module will pop up.
6. Grasp the memory module by the sides and pull it out.
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
User's Manual
Inserting the memory module
Power and Power-Up
Optional Devices
Modes).
8-5
Advertisement
Table of Contents
