Gigabyte GA-780T-D3L User Manual page 70

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Ensure
OnChip SATA Controller is enabled under Integrated Peripherals. To enable RAID for the SATA2 0/1/2/3
connectors, set OnChip SATA Type to RAID. To enable RAID for the SATA2 4/SATA2 5 connectors, set OnChip
SATA Type to RAID and set OnChip SATA Port4/5 Type to As SATA Type (Figure 1).
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
OnChip SATA Controller
OnChip SATA Type
OnChip SATA Port4/5 Type
Onboard LAN Function
Onboard LAN Boot ROM
 SMART LAN
Onboard Audio Function
USB Controllers
USB Legacy Function
USB Storage Function
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
hi: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
Appendix
Integrated Peripherals
[Enabled]
[RAID]
[As SATA Type]
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 70 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults