Gigabyte GA-780T-D3L User Manual page 59

B. Updating the BIOS
When updating the BIOS, choose the location where the BIOS file is saved. The following procedure assumes
that you save the BIOS file to a floppy disk.
Step 1:
1. Insert the USB flash drive containing the BIOS file into the computer. In the main menu of Q-Flash, use
the up or down arrow key to select Update BIOS from Drive and press <Enter>.
The Save Main BIOS to Drive option allows you to save the current BIOS file.
•
Q-Flash only supports USB flash drive or hard drives using FAT32/16/12 file system.
•
If the BIOS update file is saved to a hard drive in RAID/AHCI mode or a hard drive attached to
•
an independent SATA controller, use the <End> key during the POST to access Q-Flash.
Select HDD 0-0 and press <Enter>.
2.
Flash Type/Size.................................
Enter : Run
3. Select the BIOS update file and press <Enter>.
Make sure the BIOS update file matches your motherboard model.
Step 2:
The process of the system reading the BIOS file from the USB flash drive is displayed on the screen. When
the message "Are you sure to update BIOS?" appears, press <Enter> to begin the BIOS update. The monitor
will display the update process.
Do not turn off or restart the system when the system is reading/updating the BIOS.
•
Do not remove the USB flash drive or hard drive when the system is updating the BIOS.
•
Step 3:
When the update process is complete, press any key to return to the main menu.
Flash Type/Size.................................
Enter : Run
Q-Flash Utility v2.24
MXIC 25L1605/1606
0 file(s) found
Keep DMI Data Enable
HDD 0-0
Load CMOS Default Enable
Update BIOS from Drive
Save BIOS to Drive
ESC:Reset
hi:Move
Total size : 0 Free size : 0
Q-Flash Utility v2.24
MXIC 25L1605/1606
Keep DMI Data Enable
!! Copy BIOS completed - Pass !!
Load CMOS Default Enable
Update BIOS from Drive
Please press any key to continue
Save BIOS to Drive
ESC:Reset
hi:Move
- 59 -
2M
<Drive>
F10:Power Off
2M
F10:Power Off
Unique Features