Alg Settings - TP-Link TD-W8980 User Manual

TD-W8980
Note:
Only the WAN Ports can use MAC Address Clone function. All the clone MAC addresses must not
be the same with each other.

4.5.6 ALG Settings

Choose menu "Network" "ALG Settings", and then you can configure the basic security in the
screen as shown in Figure 4-19.
Virtual Private Network (VPN): VPN Passthrough must be enabled if you want to allow VPN
tunnels using VPN protocols to pass through the modem router.
PPTP Passthrough: Point-to-Point Tunneling Protocol (PPTP) allows the Point-to-Point
•
Protocol (PPP) to be tunneled through an IP network. To allow PPTP tunnels to pass
through the modem router, click Enable.
L2TP Passthrough: Layer Two Tunneling Protocol (L2TP) is the method used to
•
enable Point-to-Point sessions via the Internet on the Layer Two level. To allow L2TP
tunnels to pass through the modem router, click Enable.
IPSec Passthrough: Internet Protocol security (IPSec) is a suite of protocols for
•
ensuring private, secure communications over Internet Protocol (IP) networks, through
the use of cryptographic security services. To allow IPSec tunnels to pass through the
modem router, click Enable.
Application Layer Gateway (ALG): It is recommended to enable Application Layer Gateway
(ALG) because ALG allows customized Network Address Translation (NAT) traversal filters to
be plugged into the gateway to support address and port translation for certain application
layer "control/data" protocols such as FTP, TFTP etc.
FTP ALG: To allow FTP clients and servers to transfer data across NAT, click Enable.
•
TFTP ALG: To allow TFTP clients and servers to transfer data across NAT, click
•
Enable.
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router User Guide
Figure 4-19
35