Table of Contents
Advertisement
Microfilters
Unless you are instructed to use a
"line splitter" (see below), it will be
necessary to install a microfilter (low
pass filter) device for each telephone
or
telephone
device
machines, Faxes etc.) that share the
line
with
the
ADSL
Microfilters are easy-to-install, in-
line devices, which attach to the
telephone
cable
between
telephone and wall jack. Microfilters
that install behind the wall plate are
also available. A typical in-line
microfilter installation is shown in
the diagram to the right.
Note: Do not install the microfilter between the Modem and the telephone jack.
Microfilters are only intended for use with regular telephones, Fax machines and other
regular telephone devices.
Line Splitter
If you are instructed to use a " line splitter" , you must install the device between the Modem
and the phone jack. Use standard telephone cable with standard RJ-11 connectors. The
splitter has three RJ-11 ports used to connect to the wall jack, the Modem and if desired, a
telephone or telephone device. The connection ports are typically labeled as follows:
Line - This port connects to the wall jack.
ADSL – This port connects to the Modem.
Phone – This port connects to a telephone or other telephone device.
This diagram illustrates how a line
splitter should be installed.
(answering
service.
the
In-Line Microfilter
DSL "Splitter" Device
Advertisement
Table of Contents
