7.
Select the COM port that is identical to the COM port assignment in
"Windows Port". Click "Next".
8.
Click "Finish".
9.
Now you will see "RVS ISDN Modem analog" in the modem properties
list.
10. Click "Close".
11. Click "Yes", when "Modem Setup" window pops-up.
12. Click "Add" in "Remote Access Setup" dialog window.
13. Select "COM# RVS ISDN Modem analog" in RAS device list. Click
"OK". If you could not add the RAS device successfully, remove the
non-used device name , then add "RVS ISDN Modem analog".
14. Click "Continue". Then, restart Windows NT.
15. Run RVS-COM "CommCenter".
16. Go to "Control Panel"
"Properties". Select "Modem over PSTN" in "Modem choice". Click
"OK".
17. Double click "Dial-Up Networking" in "My Computer". Make new
connections via "Modem over PSTN".
"Network"
- 47 -
"Adapter". Click