Advertisement
Making Multilink PPP Connections
This ISDN TA PC Card supports the combining of two 64 Kbps data channels
into the equivalent of a single 128 Kbps line, which is known as Multi-Link
connection. To make the multilink PPP connections, firstly the PPP connection
has to be completed, and the hardware (the ISDN TA PC Card) has been
properly installed. Perform the following steps to proceed.
1.
Go to the Start menu. Point to Program. Select Configuration Utility.
Execute CONFIG.
2.
Open "General" tab. Click "MP Enabled" in "PPP Setting".
3.
Apply the other settings, "BOD Enabled" and "Second Phone No." if
available.
Making V.110 Connections
1.
Execute "Config" in Configuration Utility.
2.
Select the COM Port Setting tab. Select "V.110" for "B-Channel
protocol" in "1
3.
Make sure Dial-Up Networking is well installed.
4.
Double-click "Make New Connection".
5.
Name the new connection appropriately. For example, "V.110".
6.
Select "Intelligent ISDN MODEM (modem)" in the "Select a device"
box.
7.
Click Configure, and specify the V.110 user rate in the Maximum speed
box. Click Next.
st
COM port setting".
- 11 -
Advertisement
