Advertisement
6.
If you have entered new connection data you are prompted to save the
connection data when you Exit RVS TransferMaster. The new other party
is then added to the selection list of the field Name in the dialog box New
Connection.
Making "Modem over ISDN" Connections
The analog modem over ISDN function is availabe in two ways:
1) Use the built-in hardware fax/modem.
2) Use RVS-COM Softmodem .
Using ISDN MODEM built-in 56K modem
1.
Connect the ISDN network connection cable and hook up the ISDN line.
2.
Run RVS-COM "CommCenter".
3.
Disable the "Use Softmodem" and "Use SoftwareFax to send/receive
fax" function (refer to "Softmodem" and "SoftwareFax" tab). Click
"Apply" and "OK".
4.
Run "Config" in "Configuration Utility".
5.
Enter "General" tab.
6.
Click "Modem over ISDN B-Channel" in "Modem Setting (for RVS-
COM)".
7.
Select "Answered by Modem" in "Incoming Call Answering" (the
incoming analog calls will be answered by the built-in modem).
8.
Click "Apply" and "OK".
9.
Open "Switch type". Choose appropriate "Voice Encoding" scheme for
your location. Click "Apply" and "OK".
10. Run "HyperTerminal". Select "RVS ISDN Modem analog".
11. Now you can use the "modem over ISDN B-channel" function with
"HyperTerminal" utility or other Microsoft DUN-based application
programs (make new connections through Dial-Up Networking) to
connect to the remote parties.
Using RVS-COM Softmodem
1.
Start RVSCommCenter.
2.
Open Softmodem tab. Check Use Softmodem. Click OK.
- 25 -
Advertisement
