Acl Re-Mark Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

ACL Re-Mark Configuration

To display the following form, go to the ACL Configuration Table form, and select an ACL number, or
open the Access Control Lists folder and click Add ACL.
The following table describes the ACL Re-mark configuration controls:
ACL Re-mark Configuration controls
Table 180
Control
Set in profile update method
Set in profile user update priority
(0-7)
Set in profile update DSCP enable
Set in profile update DSCP (0-63)
Set out of profile update DSCP
enable
Set out of profile update DSCP (0-63) Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the selected
Description
Defines the method used to update 802.1p priority updates, as follows:
User defined – Sets the 802.1p priority for In-Profile packets based on the
configured value.
Use TOS precedence – Maps the TOS (Type of Service) priority to
802.1p priority for In-Profile packets.
Disabled – Disables 802.1p priority mapping for In-Profile packets.
Defines 802.1p value. The value is the priority bits information in the packet
structure.
Enables or disables DSCP updates for In-Profile packets.
Sets the DiffServ Code Point (DSCP) of In-Profile packets to the selected value.
Enables or disables DSCP updates for Out-of-Profile packets.
value.
Configuring the switch
256