Lacp Port Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

LACP Port Configuration

To display the following form, go to the Switch LACP Configuration form. Select a port number.
The following table describes the LACP Port Configuration controls:
Table 127 LACP Port Configuration controls
Control
Port Admin Key
Port Priority
Port LACP Mode
Description
Set the admin key for this port. Only ports with the same admin key and oper key
(operational state generated internally) can form a LACP trunk group.
Sets the priority value for the selected port. Lower numbers provide higher priority.
Default is 128.
Set the LACP mode for this port, as follows:
off: Turn LACP off for this port. You can use this port to manually configure a
static trunk. The default value is off.
active: Turn LACP on and set this port to active. Active ports initiate
LACPDUs.
passive: Turn LACP on and set this port to passive. Passive ports do not
initiate LACPDUs, but respond to LACPDUs from active ports.
Configuring the switch
194