Network Filter Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Network Filter Configuration

To display the following form, go to the Network Filters Configuration form. Select a network filter ID
number, or open the Network Filters folder and click Add Network Filter.
The following table describes the Network Filter Configuration controls:
Table 141 Network Filter Configuration controls
Control
Network Filter Identifier (1-256)
IP Address
Enabled?
Subnet Mask
Description
Sets the numeric identifier for this network filter.
Sets the starting IP address for this filter. The default address is 0.0.0.0.
Enables or disables the Network Filter configuration.
Sets the IP subnet mask that is used to define the range of IP addresses that will be
accepted by the peer when the filter is enabled. The default value is 0.0.0.0.
Configuring the switch
209