Table of Contents
Advertisement
DVD Player Operation
Disc Loading Steps:
1. Press the POWER button to turn on the power. Press the Input button and select DVD mode,
press the Enter button to select DVD mode.
2. Insert the disc with its printed side facing you into the disc tray. (Refer to the figure below.)
3. Disc will automatically be pulled into the disc player. While the disc is loading, "Loading" will
appear on the liquid crystal display and playback will begin.
Warning: Do not play poor quality discs that may damage the player.
DVD Playback
Region Code
DVD players and discs are coded by region. These regional codes must match the played discs. If
the codes don't match, the disc cannot be played. This player's default code is region 1.
Play
Press the
Play button to start playback. Press the STOP button once on the remote control to stop
playback, and press the Play button again to resume playback.
Stop
Press the ■ Stop button once to stop playback and then press
button twice to stop playback completely.
Play button to resume. Press this
- 30 -
Advertisement
Table of Contents
