Scsi Configuration Utility - HP D7171A - NetServer - LPr Installation Manual

Chapter 10

SCSI Configuration Utility

NOTE The Symbios Configuration Utility is not available if you leave
the NetRAID default unchanged. It is only available for LVD
SCSI mode.
If you need to verify or modify SCSI host adapter settings, or if you need to
low-level format SCSI disks or verify SCSI disk media, run the Symbios
Configuration utility:
1. Turn on or reboot your system.
2. During system start-up or reset, when the following message appears, press
the [CTRL] and [C] keys at the same time.
Press [Ctrl] [C] to start Symbios
Configuration Utility
3. Use the arrow keys to move the cursor, press Enter to select an option, and
press Esc to exit.
4. To change adapter settings:
Select an adapter from the list in the main menu.
Select Adapter Setup. This option configures the SCSI ID setting and
other advanced adapter settings.
5. To format a hard disk or change hard disk parameters:
Select an adapter from the list in the main menu.
Select Device Selections.
Select the hard disk to format.
Select Format menu option.
Configuring the HP NetServer
129