Setting Hardware Security Options; Scsi Configuration Utility - HP Tc2120 - Server - 256 MB RAM Maintenance Manual

Chapter 3
3. Select Supervisor Password or User Password.
4. Enter the password in the fields provided.
5. If you want to require a password to boot the server, select Power-on Password and then select Enable.
6. Press Esc or select Exit Menu, then select Exit & Save Changes to save your changes and exit the Setup
program.
To remove the password:
1. Follow the steps to set a password (see the previous procedure).
2. Enter the existing password when prompted.
3. For the new password, leave the field blank and press Enter.
4. Press Enter again to confirm your choice.

Setting Hardware Security Options

The BIOS Setup Utility allows you to lock certain hardware components on the hp server so that they cannot
be used. Components that can be locked include floppy disks, hard disks, CD-ROM, serial, parallel and USB
ports.
To lock or unlock a hardware component:
1. Start the BIOS Setup Utility.
To start the (BIOS) Setup Utility, boot or reboot the system and press F10 when prompted.
2. Select Advanced from the menu bar at the top of the screen.
3. Select Hardware Protection from the submenu.
4. Select the hardware component and change its setting to lock (or unlock).
5. Use the right-arrow key to select the Exit menu.
6. Choose Exit & Save Changes from the list of exit options, then press Enter.
A dialog box appears and asks you to confirm your decision.
7. Choose Yes and then press Enter.

SCSI Configuration Utility

The hp server uses the SCSISelect Utility to verify or modify the SCSI controller board settings for the devices
connected to the active SCSI connector on the SCSI controller board. If you need to verify or modify SCSI
controller settings, or if you need to low-level format SCSI disks or verify SCSI disk media, run the SCSISelect
Utility.
NOTE You typically would not need to use this utility unless you are
an experienced administrator or have been requested to do so
by a support provider.
During the boot process the BIOS searches for SCSI devices and a specific message appears if there are devices
connected to the SCSI controller board, as shown below. The SCSI controller can provide the bus, device, and
channel configurations when active on screen.
To access the SCSISelect Utility, refer to the following instructions.
1. Boot or reboot the hp server.
If you are already in the boot process, you should see the following message appear.
Installing and Configuring
49