Check The Readme File First; Configuration Assistant And Installation Assistant - HP D7171A - NetServer - LPr Installation Manual

Chapter 10

Check the Readme File First

This file includes the most recent information that was not included in the printed
installation documentation. Follow these steps to view the file.
1. Press the power-on button.
2. Press the CD-ROM drive eject button.
3. Place the Navigator CD-ROM in the drive, and press the eject button again
to close the drive.
NOTE Using the low profile CD-ROM drive is slightly different than
full-height units. The disk drawer will spring out only part way
when you push the eject button. You must manually pull the
drawer open and manually close it after inserting a CD-ROM.
4. If the system fails to boot, follow the diagnostic instructions on the screen.
5. Go to the HP Navigator Main Menu.
6. If the language needs to be changed, select User Preferences and the
language you want.
You can also change the language of the BIOS, but this is only available
when in the BIOS Setup Utility.
7. Select Readme File. Review its Table of Contents for pertinent topics.

Configuration Assistant and Installation Assistant

Before you run Configuration Assistant and Installation Assistant, you may need
to run the Symbios Configuration utility and the Setup Utility to do the following:
If you need to verify or modify SCSI host adapter settings.
l
If you need to low-level format SCSI disks or verify SCSI disk media, run
the Symbios Configuration utility.
1. Go to the Setup Utility section later in this chapter.
2. Insert the Navigator CD into the CD-ROM drive. If the system fails to
start, follow the instructions on the screen.
3. Set language, time, and date, if necessary.
4. Go to the Navigator Main Menu and select Configuration Assistant and
Installation Assistant.
5. Follow the onscreen instructions in Configuration Assistant to continue the
NetServer installation.
110
Configuring the HP NetServer