Using The Setup Screens; Scsi Configuration Utility; Hp Netserver Information Assistant; Hp Netserver Navigator Eisa Configuration Utility - HP D5970A - NetServer - LCII Service & Reference Manual

Press F2 while the prompt is displayed. More boot messages appear, followed by the message Entering
Setup... After the embedded (Symbios) SCSI Configuration initialization and the Optional ROM scan both
finish, the menu bar of the Setup Utility appears.
If you do not press F2, the HP NetServer boots normally.

Using the Setup Screens

Online help explains the settings displayed on the Setup Utility screens. Instructions are also provided for
navigating between the screens and entering or changing the setup data.

SCSI Configuration Utility

If you need to verify or modify SCSI host adapter settings, or if you need to low-level format SCSI disks or
verify SCSI disk media, run the Configuration utility:
1. Turn on or reboot your system.
2. During system start-up or reset, when the message appears, press the [CTRL] and [C] keys at
the same time.
3. Use the arrow keys to move the cursor, press [Enter] to select an option, and press [Esc] to exit.

HP NetServer Information Assistant

HP NetServer Information Assistant gives you complete access to all HP NetServer information and
documentation. HP NetServer Information Assistant allows you to search, display, and print a topic or a
series of topics. The topics cover the complete user and service information available in online format; these
can be viewed on screen and printed. Also included are system and accessory installation documentation,
NOS Guides, troubleshooting, error messages, part numbers, replacement instructions, and additional
important information.
HP NetServer Information Assistant can be accessed in two ways:
From the HP NetServer Documentation CD-ROM
On an HP Vectra or other PC running Windows 3.1 and above, Windows 95 or Windows NT,
where HP NetServer Information Assistant has been installed.

HP NetServer Navigator EISA Configuration Utility

On some older systems the EISA Configuration Utility is used and resides on the HP NetServer Navigator
CD-ROM. It can be accessed in four ways:
Express Configuration contains the EISA Configuration Utility as one of the steps and should
be used when initially setting up the HP NetServer.
Custom Configuration is used to configure or to add or remove options after initial
configuration.
Utilities Menu accesses the NetServer utilities.
Create ECU Diskette creates a copy of the EISA Configuration Utility (ECU), CFG, and OVL
files on a flexible disk.
To access the EISA Configuration Utility from the CD-ROM perform the following steps:
1. Turn on the HP NetServer and insert the HP NetServer Navigator CD-ROM in the CD-ROM
drive.
15