Cr_P-Timer Command; Cr_Tempwarn Command - Sanyo PLV-WF20 - 6000 Lumens Manual

PLV-WF20 Expand Serial Command Functional Specifications

9.11.5 CR_P-TIMER Command

Command "CR_P-TIMER" [CR]
Details Get Presentation Timer operating status
Acceptable
Response
Unacceptable

9.11.6 CR_TEMPWARN Command

Command "CR_TEMPWARN" [CR]
Get the information about the temperature inside the projector (close to the
abnormal or in the abnormal status/in the safe temperature level/abnormal status
Details is not detected).
It is possible to get the information about more than one sensor all at once if it is
applicable.
Acceptable
Response
Unacceptable
"000_%1" [CR]
"ON" ---------------------------- Presentation Timer is ongoing.
%1 "STOP" ------------------------ Presentation Timer is paused.
"OFF" -------------------------- Presentation Timer is not active.
"?" [CR]
"000_%1" [CR]
"*_*"
Sensor 1 data comes first, and then one space, after that sensor
2 data is followed.
Each data is as below:
"W"--- in or close to the abnormal temp. (Warning Temp.)
%1 "S"--- in the safe level of temperature (Safe Temp.).
"N"--- the given sensor does not detect abnormal temp.
e.g. "S_W" [CR] indicates that the temperature detected at
Sensor 1 is in the safe level while Sensor 2 in the abnormal
temperature.
"?" [CR]
65/68