Install The Oil Roller; Install The Toner Waste Box - Oki OKIPAGE8c Quick Start Manual

Install the Oil Roller

1. Remove the shipping tape from the fuser lock levers:
make sure the levers are pulled forward (in the locked
position) before proceeding.
2. Remove the oil roller from its packaging. Holding it
by the fins with the caution label facing you, lower
the oil roller into the fuser unit, sliding the left end
under the retaining ledge.
3. Make sure the blue lever is toward the back of the
printer, then lower the right end of the oil roller into
the fuser unit and pull the lever forward to lock the oil
roller in place.

Install the Toner Waste Box

1. Pull the latch on the left side of the printer and open
the side panel, then remove the three strips of packing
tape and spacers.
10
Tape
Retaining Ledge
Tape/Spacers