Changing The Ecp Setting; Changing The Media Type For Tray 1 - Oki OKIPAGE24DX User Manual

Changing the ECP Setting

The parallel port on the OKIPAGE 24DX and 24DXn supports
IEEE 1284 bi-directional mode and ECP mode. If your
computer's parallel port is not compatible with one of these
modes, the printer may not print at all or it may print
corrupted data.
To correct for this, enter the printer's Maintenance menu and
change the ECP setting to Disable.
To disable ECP:
1 Turn off the printer.
2 Press and hold MENU 1/Menu 2 while turning the printer
on, until USER MNT displays.
3 Press MENU 1/Menu 2 repeatedly until ECP appears.
/Reset to change the setting to DISABLE.
4 Press
5 Press ENTER to engage the new selection.
An asterisk appears next to DISABLE.
6 Press ON LINE to save the setting and exit the menu
mode.
|
E-116 OKIPAGE 18/24DX

Changing the Media Type for Tray 1

The printer is optimized for printing on 20-lb. (75 g/m
in Tray 1. If you consistently use another type of media, you
can change the setting to match what you are using.
To change the Media Type for Tray 1:
1 Press ON LINE.
2 Press MENU 1/Menu 2 repeatedly until MEDIA TYPE
appears on the display.
3 Press ENTER/Power Save until TRAY 1 displays.
4 Press /Reset repeatedly until the setting you want
appears on the display.
5 Press ENTER/Power Save.
An asterisk appears to indicate the new default setting.
6 Press ON LINE to save the setting and exit the menu
mode.
2 ) paper