Nothing happens but printer indicates it is ready to
receive data
Reason: Configuration error.
Solution: Check cable connection. If more than one printer is
available, make sure your printer is selected. Make sure
printer is on-line.
''Garbage'' prints
Reason: Incorrect cable configuration. (Also see "Software
Problems".)
Solution: Check cable signal continuity and length.
Printer freezes or displays error message when
computer is rebooted
Reason: Booting the computer while the printer is on can
cause a communications error.
Solution: Take printer off-line before rebooting computer.
|
E-58
OKIPAGE 18/24DX
Odors
Reason: Gases are given off by forms or adhesives passing
through the printer's fusing unit.
Solution: Make sure the forms you use can withstand
heating; provide adequate ventilation.
Change Drum message appears after only 4000 to
5000 pages are printed
Reason: Drum counter was not reset when the drum was
replaced.
Solution: Reset the drum counter (see "Replacing the Image
Drum Cartridge" in the Maintenance chapter). Always reset
the drum counter when replacing the image drum.