Setting Up Your Brewer - Keurig B60 Owner's Manual

SECTION 1
You cannot use your Keurig Brewer until
IMPORTANT:
it has been set-up for its first use as set forth below.
If Brewer has been exposed to temperatures
NOTE:
below freezing, allow Brewer at least two hours to
reach room temperature before brewing. A frozen
or extremely cold brewer will not operate.

Setting Up Your Brewer

1
fig.
Unwrap cord and plug the Brewer into
1.
a grounded outlet. Remove all pieces of
packing tape and clear plastic sticker
from LCD display.
Place a large mug (10 oz. min) on the
2.
Drip Tray Plate.
Remove the Water Reservoir from Brewer
3.
by first removing Lid from Reservoir (fig. 1),
then lifting Reservoir straight up and away
from Brewer (may be tight), (fig. 2). Rinse
with fresh water.
Set-Up & First Brew
2
fig.
Lock Tabs
Fill Water Reservoir with bottled or filtered
4.
water so that the water level is just below the
top edge of the Water Reservoir.
Place Water Reservoir base into the left side
5.
of the Brewer and be sure the Water Reservoir
Lock Tabs engage with the Brewer. Replace Lid
on Water Reservoir.
Press the Power Button found directly
6.
above the LCD Control Center (fig. 3).
7. The LCD Control Center will come on and
indicate "NOT READY" and the Small Mug
Button will also flash.
3
fig.
not be used for this Sequence
Power
Press the Small Mug Button (fig. 3).
8.
NOTE: If the Water Reservoir is empty or
NOT READY
not in place on the Brewer, the LCD Control
ADD
WATER Center will also indicate "ADD WATER." None
of the buttons will be activated until water is
added to the Water Reservoir.
Small
Mug
6
NOTE: A K-Cup should
.