U
P
S
P
SING THE
ITCH
LIDER
ERCENTAGE
You may choose a pitch operating range at any time. To change
the operating range be sure the pitch function is turned on, see
Figure 17.
The pitch percentage can be changed between +/‐4%, +/‐8%, +/‐
16%, and 100%. 4% will allow the least amount of pitch
manipulation and 100% will allow the most amount of pitch
manipulation.
To adjust the different values, press the Pitch ON/Off Button (10)
and tap on the % button (10) until your desired value is reached.
P
B
ITCH
END
This function will momentarily increase or decrease a tracks playback speed using the (‐) & (+) Pitch Bend buttons (11). The maximum pitch bend
percentage allowed is +/‐16%. The pitch bend function will work in conjunction with the Pitch Slider (8) pitch setting. For example, if the Pitch
Slider (8) is set to a 2% pitch gain the pitch bending process will begin at 0% and will continue to the maximum of ‐/+16%.
Pitch Bend Buttons (11)
The (+) Pitch Bend button (11) will provide a speed bump and the (‐) Pitch Bend button (11) will provide a slow down. The extent to which the
speed changes is proportionate to the amount of time the button is pressed. For example, if the (+) Pitch Bend button (11) is held down
continuously, the disc speed will increase and will continue to increase until it reaches a maximum of 16% speed gain. When you release the (+)
Pitch Bend button (11) the disc speed will automatically return to it's previous speed.
©American Audio® ‐ www.americanaudio.eu
S
(10)
ELECTOR
The LED of the % button (10) is glowing yellow for 4%, glowing green for
8%, or glowing red for 16%, and all LEDs glowing for 100%.
UCD‐100™
Figure 17
User Manual Page 46