39 (SOURCE SELECTOR) – Press this button to select your desired playback source. Select either CD Player, USB 1, or USB 2. The source indicator
LED will light when the selected source is activate. You can also use this button to record a demo from the current playing track.
40 (IN, OUT, & RELOOP)
• IN Button ‐ " Cue On The Fly" ‐ This function allows you to set a CUE POINT without music interruption ("on the fly"). This button also sets
the starting point of a loop.
• OUT Button ‐ This button is used to set the ending point of a loop. A loop is started by pressing the IN BUTTON, pressing the OUT BUTTON
sets the loop ending point. The loop will continue to play until the OUT BUTTON is pressed once again.
• RELOOP BUTTON ‐ If a LOOP has been made, but the CD Player is not actively in LOOP mode (a loop is not playing), pressing the RELOOP
button will instantly reactivate the LOOP mode. To exit the loop, press the LOOP OUT BUTTON.
41 (PLAY/PAUSE Button) – Each press of the PLAY/PAUSE Button causes the operation to change from play to pause or from pause to play. While
in play mode the green play button LED will glow, and while in pause mode the green play LED will flash.
42 (Stop Button) – This button is used to stop playback.
43 (Pitch Percentage & Pitch Bend Buttons)
• (‐) PITCH BEND ‐ The (‐) pitch bend function creates a momentary "Slow Down" in the pitch speed (Beats per minute ‐ BPM) when the pitch
(10) function is activated.
• 0% button‐ This button is used to change the pitch percentage to 0%.
• (+) PITCH BEND ‐ The (+) pitch bend function creates a momentary "BUMP" in the pitch speed (Beats per minute ‐ BPM) when the pitch (10)
function is activated.
44 (Keylock) – This button is used to toggle the Master Tempo function on and off.
©American Audio® ‐ www.americanaudio.eu
UCD‐100™
User Manual Page 32