Battery; Removing The Battery - HP Z210 Maintenance And Service Manual

6.
Align the PCIe card keyway with the slot key, and then firmly seat the card in the slot as shown
(3).
7.
Close the expansion card retention clamp by rotating it downward (4).
If the PCI retention clamp does not close, ensure that all cards are properly seated, and then
●
try again.
If required by the card, connect the auxiliary power cable to the card (not illustrated).
●

Battery

This section describes how to remove and install the battery.
The battery that comes with the workstation provides power to the real-time clock and has a minimum
lifetime of about three years.
WARNING!
the battery is handled improperly. Do not disassemble, crush, puncture, short external contacts, dispose
of in water or fire, or expose battery to temperatures higher than 60°C (140°F).
CAUTION:
battery is removed. To back up the CMOS settings, select the Save to Diskette option in the
Computer Setup (F10) Utility.
NOTE:
Do not dispose of batteries, battery packs, or accumulators with general household waste.

Removing the battery

To remove the battery:
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
3. Locate the battery on the system board.
ENWW
This workstation includes a lithium battery. There is a risk of fire and chemical burn if
Before removing the battery, back up the CMOS settings in case they are lost when the
Predisassembly procedures on page
Removing the side access panel on page
Removing and installing components
62).
65).
93