HP Z210 Maintenance And Service Manual page 155

Table 6-9 POST error messages (continued)
Screen message
513—Front Chassis fan not
detected
514—Memory fan not
detected
515—CPU Overtemp
occurred
516—Chipset fan not detected Chipset fan missing, disconnected, or
517—Low power CPU
heatsink(s) detected for high
power CPUs
518—Power supply wattage
insufficient for hardware
configuration
601—Diskette Controller Error
605—Diskette Drive Type
Error
610—External Storage Device
Failure
611—Primary Floppy Port
Address Assignment Conflict
912—Computer Cover Has
Been Removed Since Last
System Start Up
ENWW
Probable cause
Front fan missing, disconnected, or
defective.
Memory fan missing, disconnected, or
defective.
Insufficient processor cooling or
processor defect.
defective.
Inadequate heatsink is installed.
Computer configuration requires more
power than the power supply can
provide.
Diskette controller circuitry or diskette
drive circuitry incorrect.
Mismatch in drive type.
External storage device is not
detected, is improperly connected, or
is defective.
The flexible disk drive is configured at
a previously assigned address.
N/A
Recommended action
1.
Reseat the fan cable.
2. Reseat the fan.
3.
Replace the fan.
1. Reseat the fan cable.
2. Reseat the fan.
3.
Replace the fan.
1. If necessary, add a heatsink to the processor and
ensure proper operation.
2.
Replace the processor.
1. Reseat the fan cable.
2.
Reseat the fan.
3. Replace the fan.
Replace the low power heatsink with a high power
heatsink.
1. Reduce the computer power consumption.
2.
Replace the power supply with a high output
power supply.
1. Run the Computer Setup (F10) utility.
2.
Verify cabling and replace defective cables if
necessary.
3. Clear CMOS.
4. Replace the diskette drive.
5.
Replace the system board.
1. Run the Computer Setup (F10) Utility.
2.
Disconnect any other diskette controller devices
(tape drives).
3. Clear the CMOS.
1.
Verify that the external device is present and
connected properly.
2. Replace the external device.
Select a new address for the flexible disk drive.
No action required.
Diagnostic codes and errors
143