Installing Hard Disk Drives; Installation Guidelines - HP Z210 Maintenance And Service Manual

4.
Squeeze together at the HDD sled's green touch points (2), then slide the hard disk drive (3) out
from the chassis as shown. Support the HDD from below while you slide it out.
Figure 5-33
5. Replace the side access cover when finished.

Installing hard disk drives

Installation guidelines

The workstation typically ships with one HDD, but you can add additional drives to expand space for
programs, data storage, or backup. In general, you should plan to add HDDs starting with the first
available bay farthest from the optical drive bays.
After installation, you can use the Computer Setup (F10) Utility to:
Assign drive letters of your choice to the new HDDs. (The workstation assigns drive letters
●
automatically if you do not choose them.)
Change the boot sequence so that the workstation boots from one of the additional drives. (Disk
●
C:\ is the typical boot disk.)
See The Computer Setup (F10) Utility on page 25
ENWW
Removing the drive from the chassis
for more information.
Removing and installing components
95