Installing the front panel I/O device assembly
To instal the front panel I/O device assembly:
1.
Guide the front panel I/O device assembly cables through the chassis openings from which they
were removed.
2.
Place the front panel I/O device assembly in the chassis, and then install the fastening screws in
reverse order as they were removed.
3.
Connect the front panel I/O audio (1), USB (2) cables, and power switch/LED cable (3) to the
system board as shown in the following diagram.
Figure 5-9
NOTE:
connected to an optional 1394 expansion card or clipped to the bottom of the chassis with the
plastic clip provided.
70
Chapter 5 Replacing components
Connecting the front panel I/O device cables
The front panel I/O device assembly also has a 1394a cable. This cable can be
ENWW