Wyse Settings; The Display Tab - Neoware T5730 - Compaq Thin Client User Manual

Wyse Settings

The Display Tab

This dialog is displayed by selecting
consists of several tabs of setup options which are accessed by click-
ing on the tab titles along the top.
Note that some of the settings apply to the TVI 910+, TVI 920, TVI
925, ADDS A2 and HZ 1500 emulations in addition to the Wyse
emulations. Also, some settings may not apply to the particular
Wyse emulation currently running. Selecting a setting that is not
applicable to the current emulation will cause TeemTalk to use the
default setting for that emulation when the dialog is exited.
Tab Stops
Note: The
button is described in the section "Tab Stops" on page 224.
Lines
Factory default: 24
This option applies to the WY-50+ and WY-60 emulations and
specifies the number of data lines displayed on the screen below the
status line. Note that the other emulations only support 24 lines and a
label line.
24
25
42
43
Wyse
dialog displayed by clicking the
24 data lines and a label line at the bottom.
25 data lines but no label line.
42 data lines and a label line at the bottom.
43 data lines but no label line.
Setup Menus
Settings
in the menu. It
Set Tabs
Wyse Settings 163