Table of Contents
Advertisement
Load Specified
Session
Configuration
Disable Bell
Enable Debug (File
Capture/Replay)
Enable Debug Log
Send & Receive
If this command is not present then TeemTalk will use the start-up
commands under the Startup,Default heading.
Registry Entry: None
Command Line: -SE"description"
Default Setting: Untitled
This command enables you to override the default session configu-
ration used when TeemTalk is loaded, as specified in the
sion
dialog. The description must exactly match the description
assigned to a session configuration already saved using the
Session As
dialog and must be enclosed by double-quotes.
Registry Entry: Bell = "off"
Command Line: -BE
Default Setting: Enabled
These commands enable you to turn off the terminal bell.
Registry Entry: None
Command Line: -Debug
Default Setting: Disabled
This command is only available for NT or XP embedded versions of
the emulator. It enables the
File
the
menu which allow received host data to be logged in a file
then replayed.
Registry Entry: None
Command Line: -Debug2Way
Default Setting: Disabled
This command is only available for NT or XP embedded versions of
the emulator. It enables the
File
the
menu which allow received host data and data sent to the
host to be logged in a file then replayed.
Initialization Commands
File Capture
File Replay
and
File Capture
File Replay
and
Session Configuration
Open Ses-
Save
options in
options in
433
Advertisement
Table of Contents
