Electrical Connection; Oven Check; Fitting The Plinth; Customer Care - Rangemaster U102110-07 User Manual

Electrical Connection

This appliance must be installed by a qualified
electrician to comply with the relevant Institute of
Electrical Engineers (I.E.E.) regulations and also
the local electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED
Note
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker,
through a suitable cooker control unit incorporating a
double pole switch having a contact separation of at
least 3mm in all poles. This cooker must not be
connected to an ordinary domestic power point.
The cable size used should be between 6mm
2
10mm , twin and earth.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for
your electrical supply type (see fig.). Check that the
links are correctly fitted and that the terminal screws
are tight. Secure the mains cable using the cable
clamp.
These appliances are of type X with regard to
protection against over heating of the surrounding
surfaces.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these
instances the cooker circuit may need to be protected
by fitting 100mA device. This work should be carried
out by a qualified electrician.
Oven Light
Press the oven light switch and check that the light is
working.
NB. The oven light bulb is not included in the
guarantee
Hotplate
Check each burner in turn. Push in tap and turn to the
large flame symbol. Press ignition switch on facia
panel.
Grill
Open the grill compartment door. Turn on the grill
control and check that the grill heats up.

Oven check

Set the clock to the time of day
When the clock is first connected the display will flash
(
To set the clock to read the time of day turn and hold
the Timer knob to the clock symbol
time turn the Adjusting knob left or right until the clock
shows the time of day. Remember this is a 24 hour
clock. Let go of the Timer knob and it will spring back
to the vertical
Turn on the oven and check that the oven fan starts to
turn and that the oven starts to heat up. Turn off the
2 and
oven.

Fitting the plinth

Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central
screw. Twist and fit each end keyhole over their
respective screws. Tighten the fixing screws.

Customer care

Please complete your details in this Guide, inform the
user how to operate the cooker and hand over the
Instructions.

Thank you.

31
) and ( ) alternately.
oven manual setting.
and at the same