Error Messages - HP Jetdirect 280m - 802.11b Wireless Print Server User Manual

Error Messages

Error codes and messages that may appear in the Status sections
of the Jetdirect configuration page are described in
Table 9.12 Error Messages (1 of 10)
Error Code and
Message
02 LAN ERROR -
INTERNAL
LOOPBACK
03 LAN ERROR -
EXTERNAL
LOOPBACK
07 LAN ERROR -
CONTROLLER CHIP
08 LAN ERROR -
INFINITE DEFERRAL
09 LAN ERROR -
BABBLE
0A LAN ERROR -
NO SQE
0C LAN ERROR -
RECEIVER OFF
0D LAN ERROR -
TRANSMITTER OFF
ENWW
Description
During self-test, the HP Jetdirect print server detected an
internal loopback test error. The print server may be faulty.
If the error persists, replace the HP Jetdirect print server.
The HP Jetdirect print server is incorrectly connected to
your network or is defective. Make sure your HP Jetdirect
print server is correctly attached to your network. In addition,
check the cabling and connectors.
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.
There is a network congestion problem.
Note: If the print server is not connected to the network, this
error cannot occur.
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect print
server. For replacement instructions, see the hardware
installation guide for your print server.
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists after the printer
is turned on again, there is a problem with the HP Jetdirect
print server.
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists, there is a
problem with the HP Jetdirect print server.
HP Jetdirect Configuration Page 25
Table 9.12. +