>
>
Sending/Receiving Faxes Using the Operation Panel of the Machine
Advanced Guide
Faxing
Utility
> Starting Up Speed Dial Utility
Starting Up Speed Dial Utility
Before starting up Speed Dial Utility, confirm the following:
The necessary application software (MP Drivers and Speed Dial Utility)
is installed.
If the application software (MP Drivers and Speed Dial Utility) is not yet installed, insert the Setup CD
-ROM into the computer's disc drive, then perform Custom Install and select MP Drivers and
Speed Dial Utility.
The machine is connected to a computer correctly.
Make sure that the machine is connected to the computer correctly.
Do not plug in or unplug the USB or LAN cable when saving registered information on the computer,
or when the computer is in sleep or standby mode.
If you use Speed Dial Utility via a network connection, make sure that all the required settings have
been specified.
Make sure that the machine is turned on.
1.
Click Start and select All programs (or Programs), Canon Utilities, Speed Dial Utility,
2.
and then Speed Dial Utility.
Speed Dial Utility starts up.
>
Using Speed Dial
Page top