Table of Contents
Advertisement
Before locating the trouble, the 1
Should the same failure persist, a rewrite of the firmware may be required to confirm the function.
1. Resetting
1. Turn OFF and then ON again, re-confirm the function. Use wireless remote to reset. Also side key too.
2. Rewrite firmware or replace E-PROM chip.
2. DC voltage check
1. Check the 24V and 18V DC outputs from switching
power supply for P42LSA+, P47LSA+, LSB models.
Power supply output for 18V to supply main/LVDS
circuits and 24V for Lamp need to check at first.
2. Check the 24V and 18V voltages at the other side
of the wires. There may be a bad connection or
connector has become loose by vibration. Try
again to re-insert all the connectors so that any bad contact may be found during the process.
If there is no voltage, check the fuse in the power supply. If fuse is brown, replace it. If fuse brown again,
The power supply unit has problem inside. Replace the power unit with the same type.
If the fuse is OK but there is no output voltage or much lower than the rated value, then switching regulator may
not be switching correctly, replace the power supply unit.
3. Signal check
1. Using an oscilloscope, check the RGB or Video signal waveform.
The check points are at each input pins, be sure to supply input signals before the test.
Also, check the output at CN2 (LCD Drive Signal).
2. Check if internal test signal appears or not, by pressing I/R wireless remote control, ENTER and EXIT
Key with the sequence of ENTER, ENTER, EXIT, EXIT, ENTER and EXIT. The monitor will enter its
Test mode and display internal test signal, these are mostly flat field, white, red, green and also some
mixed colors. This is to check if the LCD drive area is OK or not.
Shut-off panel main rocker switch and turn it on again with the RGB signal supplied.
Try to replace the related circuit board or boards to check. The repair method is board replacement,
since the chip parts are so small and very difficult to replace.
4. Ballast failure
When lamps do not turn on, lamp ballast may be problematic. There are two boards located at right/left
and one of the side, the power supply connector has little more wires, this is connected to the master.
To check, replace one by one for ballast boards, one board might be broken.
5. LCD panel failure
When the picture appeared as solid vertical or horizontal lines, the LCD drive circuit or LCD might be
damaged. In this case, LCD panel assembly replacement is necessary. Please contact the
Toshiba dealer for repair action.
Discard of the product
Please refer to the page 5, this product has fluorescent lamps inside that contain a small amount of
mercury in liquid or vapor form. Discard this product in accordance with government regulations or
return to Toshiba.
st
thing will be to reset the panel and check if the condition is the same or not.
OR
43
To escape from this operation,
Advertisement
Table of Contents
