Table of Contents
Advertisement
Firmware confirmation
By using left-right button
on the screen. To escape from this mode, the main rocker power switch needs to be shut-off and turned
ON again with an RGB signal connected to display. Without RGB signal supplied, test mode continues.
Note: There are two different control methods; 1) Wireless remote control which is explained in previous chapter
2) RS232C communication using 'Video-wall control' software.
The priority for these adjustment methods, 1. RS232C 2. wireless remote.
For example during adjustment by wireless remote control, RS232C override use possible but some
operations may differ.
It is recommended to use only one control method at the time and not mix them during adjustments.
All of previous explanations are for side key switch or wireless remote control operation.
In case the RS232C control method is used, then OSD Picture appears totally different which will be
explained here after.
RS232C PC Control (control software needed)
(blacken area of wireless remote buttons display this
OSD and following adjustments are also possible)
*** Normal Mode
The buttons we can use in Normal Mode are:
[POWER], Input selections [DIGITAL], [RGB1], [VIDEO1],
[VIDEO2], [VIDEO3], the white balance selection [WB],
[CALL] status display or OSD (On Screen Display) mute,
[ADJUST] to enter adjust mode.
Right picture shows when [CALL] is clicked for Status.
Input signal selection
Sources are selected by pressing the relevant source button: [RGB1], [DIGITAL], [VIDEO1], [VIDEO2]
or [VIDEO3]. The screen will mute for approximately 2-3 seconds following source selection.
Source selection is possible in Normal Mode, there are:
Video1: Composite Video
DVI: PC digital signal, no HDCP complied
*** Adjust Mode
Press [ADJUST] to enter Adjust Mode. To exit Adjust Mode, press [ADJUST] twice (one press will request
confirmation that you wish to exit Adjust Mode).
In this mode, all the adjustments are possible.
After displaying this OSD, any adjust mode can be set.
Below shows when [CONTRAST] button is clicked.
on the wireless remote, push L-L-R-R-L-R to display firmware version
Video2: Y/C video
Video3: Y-Cb-Cr (Y-Pb-Pr) up to 480p
This left OSD shows
Contrast and its value.
The value is already set
to 50.
Two up/down
use the buttons located on the right side
27
FIRMWARE CONFIRMATION OPERATION
arrow buttons to change value, by software,
.
Advertisement
Table of Contents
