Table of Contents
Advertisement
SELECTION of the SIGNALS
Video input
VIDEO-1
Composite Video signal,
VIDEO-2
Y/C (S-VIDEO)
VIDEO-3
Y-Pb-Pr(Y-Cb-Cr)
Note: Y-Pb-Pr (Y-Cb-Cr) terminal can accept up to 720p signal.
Supplied through RGB terminal.
RGB input
RGB-1
Analog RGB (PC signal)
DIGITAL
RGB Digital
(DVI-D signal input is for PC only, HDCP: not compatible)
HD-SDI input
HD-SDI
Digital High Definition Bit stream signal
FUNCTION OF POWER PANEL
No. Name
Function
1
Power Switch Turn ON and OFF main power ON/OFF
2
AC Inlet
AC 100-240V, 50/60Hz input
POWER SWITCH AND POWER INDICATOR
AC power source is turned-on/off with the Main Power Switch.
When the Power Switch is turned-on, the Power Lamp Indicator
lights in green and the unit enters active state. It takes several
seconds typically till an image is shown after Power Switch is
turned-on.
In the active state, it is possible to power on/off with an external
controller or remote control. When power is turned-off with an
external controller or remote control, the Power Indicator light will
change to yellow and the Display unit enters standby state.
RS232C-RS485 connection hint
US-Pin (RCA)
S connector
YUV mini-DIN
Higher resolution signals are
D-sub HD 15-pin RGB analog signal/Y-Cb-Cr signal
DVI-D input
RGB digital signal for PC
BNC connector
Remarks
3P plug
15
NTSC/PAL
NTSC/PAL
NTSC/PAL/up to 480p
Interval from turn-off to turn-on
should be more than 5 seconds.
Power lamp indicates green at
Power On, No-signal and sleep
are orange, stand-by is Yellow.
Advertisement
Table of Contents
