Table of Contents
Advertisement
WIRELESS REMOTE CONTROL OPERATION
Normal Adjust Area
MENU: Enter Adjust Menu
Up button: move UP
Left button: move LEFT
Right button: move RIGHT
Down button: move DOWN
ENTER: Value Enter or Set
AUTO: Automatic picture set
EXIT: Quit function item
PIP: Display PiP on-off
SWITCH: exchange Main/PiP
SOURCE: Input selection
Pro-Adjust Area:
This is the operation of special
adjustment similar to RS232C
controls.
OSD becomes different from
Normal adjustment.
Magnification/Layout and
Pix-Effect Memory need to use
this Pro-Adjust mode.
Battery Replacement
(1)
(3)
To replace the battery inside
1) Push a little as (1) in the left picture and pull
The back cover (2) out.
2) Replace with new battery, 2 pieces of AAA type as
(3).
3) Attach back cover (2) into an original place.
4) Follow the city's law to dispose used batteries.
5) Avoid keeping used, old battery inside the
(2)
remote control, causing leakage of internal
liquid resulting metal rust or fatal damage to
the remote control hand unit.
CAUTION
Risk of explosion if the battery is replaced by an
Incorrect type or placed by wrong polarity.
Dispose of used battery according to the instructions.
18
Pro-Adjust Area
ADJ: Enter to Adjust
Mode: Mode selection (memory recall)
SPECIAL: Enter Special mode
SERVICE: Enter service mode
WB: White Balance selection
ID: Enter ID mode
0- F: ID selection
ID ENTER: Set selected ID
ID SW: ID Switch selection
ID SET: Assign ID
ID CLR: Clear ID
MAG: Magnification
LAYOUT: Picture Layout
POSI.: Picture position @ MAG
BRT: Brightness
CONT: Contrast
COLOR: Color Adjustment
OFFSET: RGB Dark Level
GAIN: RGB bright Level
TINT: Hue adjustment
R: Select Red
G: Select Green
B: Select Blue
TEST.P: Test Pattern
Advertisement
Table of Contents
