Equipment Connection And Network Setting; Required Equipment Preparation; Network Connection Using "One-Click-Communication; Function - Hitachi CP-X2 - XGA LCD Projector User Manual

2. Equipment connection and network setting

2. Equipment connection and network setting

2.1 Required equipment preparation

Followings are required for 1 projector and 1 PC connection. Multiple PC
connection is described in section 4.1.
Projector: 1 unit
PC: 1 set ("MIU Live Viewer" installation is required for "Live Mode" usage.)
IEEE802.11b/g wireless LAN equipment is required.
Depending on the type of wireless network card and PC you are using,
the projector may not be able to communicate properly with your PC,
even if the PC you are using is equipped with built-in wireless LAN

function.

To eliminate communication problems, please procure a Wi-Fi certified
wireless network card.
LAN cable (in case of wired connection): 1 piece * 1
SD Wireless Network Card (in case of wireless connection): 1 unit * 2
Memory card (in case of "PC-LESS Presentation" usage): 1 piece
* 1: When a projector and a PC are connected, use CAT-5 (or greater) LAN cable.
* 2: Access point is required when wireless LAN connection is used as
Infrastructure mode.

2.2 Network connection using "One-Click-Communication"

function
This section explains how to connect network using "One-Click-Communication"
function. This function makes PC and projector network connection very easy
without complicated settings like IP address and SSID.
* This function cannot be used when multiple PCs or multiple projectors are
connected.
* The system of Windows2000 Professional Service Pack 4 or Windows XP and
the administrator authority are required to use "One-Click-Communication"
function. (Administrator authority)
* This function only works when the network settings of the projector is the same
as factory default settings.
* This function might not work depending on your used wireless LAN driver.
If so, setup the connection manually. (10, 16 and refer to the User Manuals for
your PC and wireless equipment.)
[Wired LAN connection]
1) When projector network settings such as IP address and subnet mask are
changed, need to return to the projector factory default Network settings.
q P ress the MENU button on remote control or the ▲/▼/◄/► button on
keypad. Then OSD menu will be displayed. If Easy Menu is displayed,
change the menu to Advanced Menu.
8