Table of Contents
Advertisement
4.6 Event Scheduling (Continued)
Date/Time Settings (31)
The Date/Time setting can be adjusted via a web browser.
Example: If the IP address of the projector is set to 192.168.1.10/:
1) Enter [http://192.168.1.10/] into the address bar of the web browser.
Enter the Administrator ID and Password and click [Logon].
2) Click [Date/Time Settings] on the main menu and configure each item. Refer
to the [Date/Time Settings] item in "Configuring and controlling the Projector
via a Web Browser" for further information.
3) Click the [Apply] button to save the settings.
NOTE
• The battery for the built in clock may be dead if the clock loses time
even when the Date and Time have been set correctly. Replace the battery by
following the instructions on replacing the battery.
(Internal clock battery of the User's Manual - Operating Guide)
• The Internal Clock's time may not remain accurate. Using SNTP is
recommended to maintain accurate time.
4. Utilize projector – Advanced -
Advertisement
Table of Contents
