C
ALIBRATION
15 After you hear a beep, slide the ES-1000 at a slow but consistent pace across the strip.
Take about five seconds to slide the length of the strip.
16 Release the button when all the patches in the strip have been measured and you reach the
white space at the end of the strip.
When a strip is measured successfully, the cross hair moves to the next color.
If the strip is not measured successfully, a message directs you to try again.
17 Repeat steps
13
through
N
:
You must measure in the order outlined in the Status field.
OTE
18 When all the patches have been read successfully, click Accept.
19 Click Apply in the Calibrator dialog box.
The new calibration measurement is applied.
20 Click OK in the Information dialog box.
This completes the Fiery EXP6000/EXP5000 calibration process.
16
until all the strips are measured.
52