EFI DocuColor 5252 Supplementary Manual page 48

C
ALIBRATION
8 Click Measure.
9 If necessary, choose the appropriate COM port for the DTP41 from the Available Ports menu,
and then click Start Measurements.
10 Feed the measurement page into the DTP41, starting with the cyan strip.
Align the page in the measurement page slot of the DTP41 so that the appropriate color
column is centered below the alignment mark (see the diagram on
about three inches, past the front idler rollers, until it rests against the rear drive rollers and
you feel resistance.
11 Click Read Strip.
The DTP41 pulls the measurement page through automatically.
After the measurement page is read, Calibrator instructs you to insert and realign the page for
the next color.
48
page 79). Insert the page