Kyocera KM-3035 Operation Manual page 45

13
Use the keypad to enter the desired subaddress and
F-Code password. (Maximum 20 digits)
* To switch between the subaddress and password input
screens, press the "Password" key.
* A subaddress is required during F-Code Based
Communication in order to designate the other party's
corresponding F-Code Box.
* An F-Code password is used during F-Code Based
Communication. However, you do not have to enter an
F-Code password here if you have determined in
advance with the other party not to use one.
(inch)
(metric)
14
Press the "Close" key twice and then go directly to step
20.
15
If you want to designate this key for Encrypted
Transmission, press the "Encryption TX" ["Encryption"]
key.
16
To use this key for Encrypted Transmission, press the
"On" key. The Key Code/Box Number Input screen will
appear.
Section 2 Fax Operation (Basic Use)
17
Use the keypad to enter the 2-digit Key Code (01 - 20)
that corresponds to the Encryption Key you want to use
for this one-touch key.
(inch)
(metric)
18
Press the "Encryption box #" key and then use the keypad
to enter the number of the destination party's Encryption
Box.
19
Press the "Close" key twice.
20
To register this one-touch key with the entered
information as is, press the "OK" key.
The message display will return to the same screen as
was displayed in step 3.
If you want to continue registering other one-touch keys,
repeat steps 3 through 20.
21
If you are finished making settings, press the Reset key to
return to the initial mode.
2-15