Polling Reception - Kyocera KM-2560 Operation Manual

Fax system (m) operation guide rev-2.0
Hide thumbs Also See for KM-2560:
Table of Contents

Advertisement

FAX Operation (Advanced)

Polling Reception

5-68
This function automatically triggers transmission of originals stored on the
sending machine when the receiving machine dials the sending machine's
number. If multiple contacts are specified, they are dialed in sequence and
originals are received from each contact.
NOTE:
By setting a group as the destination, you can receive originals
from up to 500 contacts in a single operation. If you specified a destination
for which encrypted communication is registered, encrypted
communication is disabled for polling reception.
When the Dual FAX option is installed and a receive-only port is specified,
communication is via the other port.
To use polling reception, you must first ensure that the sending machine is
set up for polling transmission. (Refer to Polling Transmission on page 5-
64.)
Using Polling Reception
NOTE:
When the other party is using sub addresses, refer to Using
Polling Reception with Sub Addresses below.
1
Press the Send key.
2
Select the destination.
NOTE:
Only fax numbers can be selected as destinations.
You can select destinations using a combination of numeric keys input and
Address Book or One-touch keys selection.
3
Press [Advanced Setup], and then [FAX Polling RX].
4
Press [On].
5
Press [OK].
6
Press the Start key. The operations for reception begin.
Ready for FAX Polling RX.
FAX Polling RX
Dial the destination and receive documents
for Polling Transmission stored in
the polling box.
Press [OK] to display
the image.
Add Shortcut
Status
Destination
Off
On
Cancel
OK
6/6/2006 10:00
OPERATION GUIDE
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Km-3050Km-3060Km-4050Km-5050

Table of Contents