Wan - Edimax Broadband Router User Manual

Port
Enabled
Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance
sections or start using the router (with the advance settings in place)

2.2 WAN

Use the WAN Settings screen if you have already configured the Quick Setup Wizard section and you would like to
change your Internet connection type. The WAN Settings screen allows to specify the type of WAN port connect you
want to establish with your ISP. The WAN settings offer the following selections for the router's WAN port, Dynamic IP,
Static IP Address, PPPoE, PPTP, L2TP, Telstra Big Pond, DNS and DDNS.
Parameters
Dynamic IP
Static IP
PPPoE
PPTP
L2TP
Telstra Big Pond
DNS
DDNS
Once you have made a selection, click <More Configuration> at the bottom of the screen and proceed to the manual's
relevant sub-section
by port number 8080, e.g. 10.0.0.1:8080 (see below). You'll also need to know the
password set in the Password Setting screen in order to access the router's web-
based management.
The port number of remote management web interface.
Select "Enabled" to enable the remote management function.
Your ISP will automatically give you an IP address
Your ISP has given you an IP address already
Your ISP requires PPPoE connection.
Your ISP requires you to use a Point-to-Point Tunneling Protocol (PPTP) connection.
Your ISP requires L2TP connection.
Your ISP requires Telstra Big Pond connection.
You can specify a DNS server that you wish to use
You can specify a DDNS server that you wish to use and configure the user name and
password provided by you DDNS service provider.
Description
19